1999 Chevrolet Silverado Tail/ license/brake lights

Tiny
JIMS992500
  • MEMBER
  • 1999 CHEVROLET SILVERADO
  • 7.4L
  • V8
  • 4WD
  • AUTOMATIC
  • 208 MILES
1999 OBS Silverado, I have no tail or any brake lights. At one time there was a 7 pin on the truck because from the front of the truck I have a large blue and large red/orange wire. In addition to those I also have the normal wires for a 4 pin and the light green for reverse. In the back of the truck I have the normal 3 wires for turn/brake and tail lights. Now, coming from the front I also have a small blue wire that I have no clue where it goes and in the back I have a large black and even larger white wire. What am I hooking up in order to get my tail lights and brake lights to work? I have turn signals and reverse lights but that's it! No tail/brake/license plate lights.
Saturday, June 7th, 2014 AT 7:28 PM

2 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
There is a circuit board on back of frame on drivers'side or should be it is a brown wire that runs all the taillights and license lights. There is also a ground on lh side of frame and that should be clean and free of corrosion. There are also fuses underhood for the lh and rh parking lights.
Was this
answer
helpful?
Yes
No
+1
Sunday, June 8th, 2014 AT 10:48 AM
Tiny
JIMS992500
  • MEMBER
  • 1 POST
There isn't a board/block on the back of mine, it is just looms. Grounds are good, fuses and relays are good under hood and in cab
Was this
answer
helpful?
Yes
No
Sunday, June 8th, 2014 AT 11:24 AM

Please login or register to post a reply.

Sponsored links