1999 Chevrolet Malibu help

Tiny
DJYANCEY
  • MEMBER
  • 1999 CHEVROLET MALIBU
  • 2.4L
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 205,000 MILES
Is a 99 Malibu 2.4 dohc an interference engine? Reason being, I had my water pump done last week. When I get it back, the car is idling higher than normal and cuts off when I slow down to a stop. The very next day there is a loud knock noise when I crank it and drove it to work. Cut off multiple times. I took it back and the mechanic said I had slung a rod from being a half a quart low on oil. I feel like he is trying to get over
Thursday, August 21st, 2014 AT 5:04 PM

7 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,867 POSTS
Is this the Quad 4 engine? If so, it is an interference engine. And being 1/2 quarts low on oil will not spin a rod bearing.
Was this
answer
helpful?
Yes
No
+1
Thursday, August 21st, 2014 AT 5:13 PM
Tiny
DJYANCEY
  • MEMBER
  • 4 POSTS
Yes it's the quad 4
Was this
answer
helpful?
Yes
No
Friday, August 22nd, 2014 AT 7:11 PM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,867 POSTS
Yes, it is an interference engine. However, that small amount of oil wouldn't have caused the engine problems. Heck, my sis in law just stopped and asked if she needed oil. She was 3 quarts low. No that isn't a good thing to do, but the engine is fine.
Was this
answer
helpful?
Yes
No
Friday, August 22nd, 2014 AT 7:35 PM
Tiny
DJYANCEY
  • MEMBER
  • 4 POSTS
So, could he have been the one to mess the timing up? And possibly bend the valves. Or cause it too run awful. Sling a rod?
Was this
answer
helpful?
Yes
No
-1
Friday, August 22nd, 2014 AT 9:05 PM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,867 POSTS
Well. Your water pump is run by a timing chain. The chain tensioner needs to be removed to complete the job. Did the car ever run properly for you after you got it back?
Was this
answer
helpful?
Yes
No
Sunday, August 24th, 2014 AT 8:51 PM
Tiny
DJYANCEY
  • MEMBER
  • 4 POSTS
No, it didn't run properly on the way home. And the very next morning it was knocking.
Was this
answer
helpful?
Yes
No
Monday, August 25th, 2014 AT 7:25 PM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,867 POSTS
Something was wrong with it then.
Was this
answer
helpful?
Yes
No
Tuesday, August 26th, 2014 AT 5:40 AM

Please login or register to post a reply.

Sponsored links