Advertisement

engine not running?

143,000 MILES • 3.0L • 6 CYL • FWD • AUTOMATIC
Avatar
ERIKNOEL1
  • MEMBER
  • 1 POST
Getting on the on ramp getting up to speed. And all of a sudden. Motor stopped working. Still had electricity gauges etc. No noices, van still turns over. Fuel pump sounds like it's engaging. What could be a easy place to start? Sensors? Filter? Timing chain? I'm at a loss.
May 7, 2015 at 11:00 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,415 POSTS
The first step is to read and record the diagnostic faults. Chrysler makes that much easier to do yourself than any other manufacturer. Cycle the ignition switch from "off" to "run" three times within five seconds without cranking the engine, leave it in "run", then watch the code numbers show up in the odometer display. List those codes here, then we'll figure out how to proceed.
May 7, 2015 at 11:24 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle