Rear wiper won't shut off

CARADIODOC

MECHANIC
33,916 POSTS

I would think so but I never worked on one. Can you measure the resistances in the switch? How many wires are on the switch, one or two? If there is only one, there will be something metal on the switch that has to be grounded. The manual shows a different ground location so I'm guessing there are two wires on the switch.

SPONSORED LINKS

Was this

answer

helpful?

Yes

Tuesday, March 22nd, 2011 AT 2:03 AM

RUBANTIN

MEMBER
36 POSTS

Yes, there are two wires. I will measure the resistance tomorrow.

Was this

answer

helpful?

Yes

Tuesday, March 22nd, 2011 AT 2:38 AM

RUBANTIN

MEMBER
36 POSTS

Ok. There are 3 positions. Clockwise is 670ohms, straight is open and counterclockwise is 4Kohms

Was this

answer

helpful?

Yes

Tuesday, March 22nd, 2011 AT 7:33 PM

RUBANTIN

MEMBER
36 POSTS

Ok. I was making more work than necessary. I just pulled the wire harness off the old one and plugged it in. I plugged in the security lock switch and turned it. The doors locked and unlocked, so I am on track. I am in process of putting the new BCM back in and will initiate the procedure you outlined above. Will let you know how it goes.

Was this

answer

helpful?

Yes

Tuesday, March 22nd, 2011 AT 8:05 PM

RUBANTIN

MEMBER
36 POSTS

DONE>>>> HOORAY! It works! Ok. Thank you thank you thank you.

One last question. Will anything be adversely affected if I leave the new harness in without the security switch?