Removal Procedure
Notice: Numbers in text correspond to numbered components in image.
Raise the vehicle and support.
Remove the electrical connector at the crank sensor located on the front engine bank.
Remove the retaining bolt (1) and crank sensor (2 or 3).
Installation Procedure
Install the crank sensor (2 or 3) and the retaining bolt (1). Tighten the retaining bolt to 10 Nm (89 lb in).
Lnstall the electrical connector at the crank sensor.
Lower the vehicle.
Image (Click to make bigger)
SPONSORED LINKS
Saturday, February 12th, 2011 AT 12:11 AM