I have a vibration upon accelerating

1993 ACURA INTEGRA
247,000 MILES
Avatar
REEPER ICEMAN
  • MEMBER
  • 3 POSTS
Ok I have a 1993 acura integra ls. When I accelerate I get a vibration. I have no clue what it is. It's not the cv axles I have checked them. I'm really stumped what it could be. It's not the motor mounts either. Could the ball joints be bad? This happens only when I accelerate on all gears it doesn't happen when I shift down or decelerate. It stops when I let off of the gas. I have checked the axles and motor mounts. I'm kinda stumped could it be the ball joints cause this to do this or perhaps differential bearings In the transmission?
Oct 17, 2011 at 11:56 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Honestly, it sounds like one of the rubber mounts on a motor or trans mount is bad. The motor mounts make more sense. How did you check them? Was the engine under a load?
Oct 18, 2011 at 12:00 AM
Avatar
REEPER ICEMAN
  • MEMBER
  • 3 POSTS
yes it was under a load. There is no movement to the engine. I have no clue what it could be. I am just really stumped.
Oct 26, 2011 at 1:39 AM
Avatar
REEPER ICEMAN
  • MEMBER
  • 3 POSTS
Could it be a intermediate shaft if so how do I check this?
Oct 26, 2011 at 11:21 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.