Wrong engine diagram

RCHRISW1

MEMBER
1991 MITSUBISHI 3000GT
6 CYL
4WD
AUTOMATIC

My engine is a 3.0 with 12 valves and only has 2 cam sprockets and the diagram you showed is 24 valve and has 4 sprockets please send me the 12 valve diagram.
Thanks

Monday, November 22nd, 2010 AT 9:52 AM

3 Replies

KHLOW2008

MECHANIC
41,814 POSTS

See if the following helps.

Images (Click to make bigger)

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Monday, November 22nd, 2010 AT 10:06 AM

RCHRISW1

MEMBER
3 POSTS

Yes that was very helpful And exactly how I have them set already so that is off my mind now. However. It still will not start. I can hear the fuel pump run when I turn the key on and I have a good spark at the coil wire, The rotor points to #1 at TDC of the compression stroke. Is there something I'm overlooking with the fuel or spark timing that could be causing this to not start up?

Was this

answer

helpful?

Yes

No

+1

Monday, November 22nd, 2010 AT 10:55 AM

KHLOW2008

MECHANIC
41,814 POSTS

You have sparks and fuel pressure, but are the injectors pulsing?

Try spraying some starting fluids and see if it starts.
If vehicle had not been started for an extended period, the compression could be low due to the piston rings drying out. Test the compression and if low, remove the sparl plugs. Pump a little engine oil into the cylinders and crank the engine for a few seconds. Recheck the compression. If compression has increased, reinstall the spark plugs and try starting again.

Ensure the cranking speed is good as a weak battery might not crank the engine fast enough to get it started.

Was this

answer

helpful?

Yes

No

Monday, November 22nd, 2010 AT 11:11 AM