90 Ford Escort won't start or idle

Tiny
TY SCHIFFMAN
  • MEMBER
  • 1990 FORD ESCORT
  • 4 CYL
  • FWD
  • AUTOMATIC
90 ford escort 1.9l auto trans w/cfi. Car will start with a little gas in throttle body but won't idle or start on it's own, you can keep it running by pumping the throttle, 22 was the only codes I was getting now 22, 31, and 96. Fuel pressure seems to test fine about 14 psi when pump running.
Monday, November 22nd, 2010 AT 11:29 PM

5 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check and test the idle control motor/valve and EGR valve and throttle position sensor and MAF sensor
Was this
answer
helpful?
Yes
No
Monday, November 22nd, 2010 AT 11:50 PM
Tiny
TY SCHIFFMAN
  • MEMBER
  • 4 POSTS
I have checked idle control motor and the throttle position sensor and they checked out ok, I will have to check egr valve and I don't believe it has a maf sensor. Would the egr cause these problems? How do you check the the other sensor that refers to code 22? (Can't remeber what it is called of hand)
Was this
answer
helpful?
Yes
No
Tuesday, November 23rd, 2010 AT 12:41 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check and test the MAP sensor-

Ford

Diagnostic Trouble Codes - 1990

11 System "pass"
12 Unable to control RPM to Self Test upper limit band.
13 Unable to control RPM to Self Test lower limit band.
14 PIP circuit failure.
18 No tach.
19 Failure of EEC power supply.
21 ECT out of range.
22 MAP out of range.
23 TPS out of range.
29 Insufficient input from Vehicle Speed Sensor.
31 PFE circuit is below minimum.
32 EGR valve not seated.
33 EVP not closing properly.
34 No EGR flow.
35 PFE circuit is above maximum voltage.
39 AXOD converter bypass not applying correctly.
41 HEGO sensor circuit indicates system lean (Right HEGO).
42 HEGO sensor circuit indicates system rich (Right HEGO).
51 ECT sensor input too high.
52 Power steering pressure switch is open.
53 TPS input too high.
54 ACT (VAT) input too high.
57 AXOD Neutral Pressure Switch open.
59 Transhydraulic switch (THS 3/4) failed in open position.
61 ECT input too low.
63 TPS input too low.
64 ACT (VAT) input too low.
67 AXOD Neutral Pressure Switch closed.
68 AXOD Transmission Temperature Switch open.
69 Transhydraulic switch (THS 3/2) failed.
70 EEC-IV data transmission circuit failed.
71 Cluster Control Assembly circuit failed.
72 Message Center Control Assembly circuit failed.
74 Brake on/off circuit failed.
79 A/C on during Self Test.
83 High speed Electro Drive Fan circuit failure.
84 EGR Vacuum Regulator circuit failure.
85 Canister purge (CANP) circuit failure.
87 Fuel pump primary circuit fault.
88 Electro Drive Fan circuit failure.
89 AXOD Lock Up Solenoid circuit failure.
91 HEGO sensor circuit indicates system lean (Left HEGO).
92 HEGO sensor circuit indicates system Rich (Left HEGO).
95 Fuel pump secondary circuit failure.
96 Fuel pump secondary circuit failure.
Was this
answer
helpful?
Yes
No
Tuesday, November 23rd, 2010 AT 2:46 AM
Tiny
TY SCHIFFMAN
  • MEMBER
  • 4 POSTS
Sorry it took so long to reply (no power) how do you test map sensor? Have not found out how to online yet, any help would be appreciated thank you.
Was this
answer
helpful?
Yes
No
Wednesday, November 24th, 2010 AT 4:38 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Go to this link: http://www.youtube.com/watch?v=B8EVhFc5Yqw
Was this
answer
helpful?
Yes
No
Wednesday, November 24th, 2010 AT 8:36 PM

Please login or register to post a reply.

Sponsored links