NISSAN HARDBODY ENGINE

Found 104 results

Select a filter to limit the results

Symptoms Camshaft Computer Crankshaft Cylinder Head Idle Air Control Intake Manifold Interchange Mass Air Flow Sensor Mount Oil Filter Oil Pan Oil Pump Oxygen Sensor Replace/Remove Serpentine Belt Starter Throttle Body Timing Belt Timing Chain Tune-up Turbo Vacuum Hose Diagram Wiring

Will Not Stay Running

The Car Do Start But After Some Seconds Goes Off.

Asked by Mokolokau11 ·

1 ANSWER

22 IMAGES

2011

NISSAN HARDBODY

Turn Over an Engine by Hand | Bar Over

VIDEO

Turn Over an Engine by Hand | Bar Over

Instructional repair video

Code Reading

A check engine light, also known as a service engine light, or a MIL (malfunction indicator light) is designed to let you know there is a problem with one of your car's...

Fuel Pressure, Will Not Stay Running

Need To Know The Fuel Pressure On This Truck, Furthermore It Start A Few Seconds Then Shuts Off. Ignition Is Good Sparks All Around But...

Asked by pacificislander ·

14 ANSWERS

5 IMAGES

1996

NISSAN HARDBODY

Engine Surges

Okay, All Prior Issues Resolved With One Exception. I Will Describe. 1. Wiring Harness Issues. Fixed 2. Vacuum Hoses All Hoses...

Asked by Jclemo ·

19 ANSWERS

8 IMAGES

1997

NISSAN HARDBODY

Timing Marks

I Have The Truck Listed Above With A Ka20 Petrol Engine. Got New Timing Chains. The Top Chain Got Markings. The Bottom Chain Does Not Have...

Asked by Ryaz ·

1 ANSWER

13 IMAGES

2004

NISSAN HARDBODY

Shuts Off While Driving, Code P0180, Fuel Temperature...

After Warms Up It Shuts Off When I Stop And While Driving. Code P0180 Fuel Temperature Sensor Is The Only Code. Would The Fuel Sensor Make...

Asked by Billie Schneider ·

1 ANSWER

2 IMAGES

1996

NISSAN HARDBODY

Blown Head Gasket?

Hi There, My Truck Listed Above 16v Td King Cab. Once Overheat When I Checked The Radiator Was Almost Empty I Topped It Up. After That I...

Asked by Norman T Motsi ·

21 ANSWERS

3 IMAGES

2007

NISSAN HARDBODY

P1000 Trouble

A P1000 code is designed to inform the driver the engine management system is not working to it's full potential. When in open loop, the powertrain management system is...

Still Will Not Start After Replacing Crankshaft Sensor

I Replaced The Crankshaft Sensor But It Still Won't Start.

Asked by Hannah Rhoten ·

1 ANSWER

6 IMAGES

1997

NISSAN HARDBODY

Stalls While Driving

My 1997 Hard Body Will Stall But Not All The Time. It Will Stall After About A Half Hour And Will Easily Start Again. It Has Tried To...

Asked by Nugget ·

12 ANSWERS

2 IMAGES

1997

NISSAN HARDBODY

Still Will Not Start, Why Won't It Start?

Hi My Name Is Cassandra I Have A 1991 Nissan Pickup That Has Had The Fuel Pump, Starter, Ignition Module, And Distributed Changed And The...

Asked by casandrap ·

2 ANSWERS

1991

NISSAN HARDBODY

When Transmission Is Put Into Drive/reverse It Shuts...

My Truck Starts Up Rough And Smooths Out A Bit After Warming Up. Once I Put It Into Drive/reverse It Shuts Off.I Can Keep It Running If I...

Asked by Garrett Hopkins ·

1 ANSWER

1987

NISSAN HARDBODY

Ask a new Nissan Hardbody question

Ask a Car Question. It's Free!

© 1999 - 2025 2CarPros, Inc.