Mitsubishi


Where Is The Reversing Light Switch Located?

2003 MITSUBISHI L200
Recent Purchase, Reverse Lights Are Not Working, Not Bulb Or Fuses Etc., Wiring Seems Okay. Think It’s The Switch But Struggling To Find...
3 ANSWERS
1 IMAGE
Asked by Mighty-Max

Cruise Control Does Not Work?

2003 MITSUBISHI OUTLANDER
I've Tried Engaging This. The Cruise Light Comes On, But When I Reach The Desired Speed And Try To Engage Cc, It Doesn't Work, The...
1 ANSWER
2 IMAGES
Asked by arn2012

Automatic Transmission Controller Pinouts On 26 Pin...

1996 MITSUBISHI COLT
Looking For Pinouts For Rpm Signal And Tps To Gearbox Controller It Has A 26pin Plug Part Number On Controller Mr145308.
6 ANSWERS
8 IMAGES
Asked by Esias Nothling

Where Is The Transmission Filter Located?

2001 MITSUBISHI ECLIPSE
I Couldn't Find Any Videos Or Helpful Information On How To Replace It Or Anything Else.
1 ANSWER
1 IMAGE
Asked by Slide65

Cranks Have No Spark And No Fuel Out Of Injectors?

2007 MITSUBISHI GALANT
Cranks. It Has No Spark And No Fuel Out Of Injectors. New Crank Sensor. Tps Is Whining With Car In Run Position. I Just Replaced The...
7 ANSWERS
1 IMAGE
Asked by Michael Juarez Jr.

Compatible Struts?

2015 MITSUBISHI OUTLANDER
I Have Been Looking For A Complete Strut Assembly For My Vehicle Listed Above Se Model With 3rd Row. I Cannot Find Them Anywhere I Have...
2 ANSWERS
Asked by Troy Williams2

Loud Engine At 2,500 RPMs?

2003 MITSUBISHI OUTLANDER
Highway Driving When I'm At 2,500 Rpms, Usually At About 70 To 80 Kph, The Engine Noise Is Bearable, Though Still Loud By Usual...
5 ANSWERS
Asked by arn2012

Car Shudders When I Brake During Highway Driving?

2003 MITSUBISHI OUTLANDER
During City Driving, All Is Well. However, After About 15 Mins Of Highway Driving (speeds Of 80kph And Above), When I Have To Slow Down...
3 ANSWERS
Asked by arn2012

Low Beam Headlights Do Not Work?

2015 MITSUBISHI OUTLANDER SPORT
The Two Bulbs On The Passenger Side That Are Supposed To Light When The Low Beams Are Turned On Don't. There Is Power To The Blue Wire...
3 ANSWERS
7 IMAGES
Asked by Jeff Herman

Code P0733 Incorrect Gear 3 Ratio?

2005 MITSUBISHI ENDEAVOR
Incorrect Gear 3 Ratio. Drives Fine Till 3rd And Then Shutters And Sets The Code Off. Input Shaft Sensor Replaced But Still Same....
1 ANSWER
Asked by Lee h0000
Ask a new Mitsubishi question