Mazda
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
Exhaust Manifold Connection To Exhaust Pipe
I Recently Installed An Exhaust Manifold To The Engine In My Truck. It Seems Not To Line Up Flush With The Three Studs On The Exhaust Flange...
Asked by Herschel Copeland
Cam Shaft Sensor Location Needed
Can I Know The Position Of The Cam Sensor On The Car Listed Above 1.25l?
Thanks
Asked by Mido
Lack Of Power
Runs Good In Idle But When Start To Move The Engine Diesels And Spits And Sputters And Can't Get It To Move Faster Than 10 Miles An Hour...
Asked by Justin Lee Kelly
Alternator Replacement
Hello, I'm Am Almost Finish Putting Everything Back Together From Doing Head Gasket. I Want To Thank Everyone Who Helped Me Through That...
Asked by Chefdre621
RPMs Do Not Go Above 1,000
I Serviced The Car A Month Ago And Put Some Diesel Fuel Additive To Clean The Carbon Through The System. I Ran The Car For About 40 Miles...
Asked by Craig74
Engine Coolant Temperature Sensor (F)-40?
My Coolant Temperature Is Reading -40 Degrees. I Replaced The Sensors And The Pcm Still No Change. I Have Loss Of Power Because Of The Low...
Asked by Chase1041
Shifter Post ECM Replacement
I Bought The Car Listed Above That Needed A New Ecm. We Cranked The Car Before Bumper Pulling It Just To See If It Would Start. It Did...
Asked by KeelyAleeceShanks
Alternator And Starter Wiring Diagram Needed
Hello,
Can Someone Help Me Figure Out It How The Alternator And Starter Wiring Is?
I Just Did A Head Gasket And I'm Putting...
Asked by Andre Battis
Ask a new Mazda question
