Mazda Drivetrain
Browse Mazda Drivetrain questions and answers. Choose a question that matches your symptoms.
898 discussions
1997 Mazda 626 1997 Mazda 626 Es Wont Go Into 3rd And...
I Have A 1997 Mazda 626 Es That Will Not Shift Into 3rd Or 4th Gear, Sometimes It Will Hard Shift Into 3rd But It Revs Up To 4 Or 5 Rpms...
Asked by taylorr01234
1997 Mazda 626 Clutch Replacement
Drive Train Axles Bearings Problem
1997 Mazda 626 6 Cyl Manual 180000 Miles
Over The Last Week Or So, I Have Been Having Trouble When...
Asked by beefykins
1997 Mazda 626 Transmission Speed Sensor Replacement
Engine Performance Problem
1997 Mazda 626 4 Cyl Front Wheel Drive Automatic
The Code Says That The Speed Sensor Is Bad. How To Replace...
Asked by micar
1997 Mazda Protege Clutch Master Cyclinder
Is My Clutch Master Cyclinder Going Bad Because I Just Replaced A Slave And It Seems Like When I Shift Its Not Buiding Up Enough Pressure To...
Asked by tlebo
1997 Mazda Protege Clutch Problems
I Just Replaced My Clutch And Slave Cyclinder And I Bleed It And I Got All Air Out. And I Went To Drive It And I Lost All Pressure In The...
Asked by tlebo
1997 Mazda MX6 Clutch To Floor.
Recently I Noticed My Clutch Pedal Would Not Come Up More Than Halfway When Depressed. The Car Has A Combination Reservoir For The Brake And...
Asked by silverbullet91
1997 Mazda Protege Will Not Shift Out Of Park
Transmission Problem
1997 Mazda Protege 4 Cyl Two Wheel Drive Automatic
Hi,
My 1997 Mazda Protege Will Not Shift Out Of Park. I Have...
Asked by mazdaprotegewi
1997 Mazda 626 O/D OFF Light Blinking
The O/d Off Light Starts To Blink After Driving For About 20 Miles (or Less). The Car Drives Fine Until I Stop And Start To Go Again, At...
Asked by et2431
1997 Mazda Miata Clutch
I've Owned This Car For Almost 7 Years. Yesterday, My Clutch Apparently Ran Out Of Fluid. It Went To The Floor And I Couldn't Change Gears....
Asked by Steve Loscalzo
1997 Mazda Millenia Transmission Repair
I Have An Automatic Transmissio On My Mazda Millenia And When It Gets To 3rd Gear It Slips.
I Was Hoping There Was A Way To Fix This...
Asked by erpl
Browse other repair topics
Can’t find your issue?
Ask a new Mazda question
