Kia Sorento Drivetrain

Browse Kia Sorento Drivetrain questions and answers. Choose a question that matches your symptoms.

64 discussions

Need Factory Radio Pinouts?

2020 KIA SORENTO
I Am Looking To Find The Vehicle Reverse + Signal For Install Of An Aftermarket Stereo. I Was Looking For The Pinout Of The Factory Radio...
1 ANSWER
6 IMAGES
Asked by SA0560

Electrical Diagram From Shifter Interlock Solenoid?

2019 KIA SORENTO
Hi, My Car Is Stuck In Park. Just Wondering If You Have An Electrical Diagram From Shifter Interlock Solenoid Going To Main Box. The Problem...
1 ANSWER
2 IMAGES
Asked by DIY Troubleshooter

Rear Coupler

2014 KIA SORENTO
My Rear Coupler Was Replaced A Few Months Ago At The Dealer. Then My Awd Light Came On And They Said It Was A Sensor. Now They Are Saying My...
1 ANSWER
Asked by Amanda L Johnson

When Warmed Up Transmission Does Not Shift Properly

2014 KIA SORENTO
When Car Is Cold, It Shifts Fine. But When The Car Is Warmed Up, If I Start From, Park, To Drive, The Car Will Jerk, Then Go. Sometimes...
3 ANSWERS
6 IMAGES
Asked by Nsteele

Making A Growling Noise During Start Up?

2013 KIA SORENTO
It Becomes Louder During Reverse And Acceleration. It Disappears Once Driving. The Engine Was Recently Replaced Due To A Recall A Year Ago.
1 ANSWER
Asked by Steele79

Clutch/flywheel

2012 KIA SORENTO
Push Down The Clutch And Turn On The Key Hear A Sound.
3 ANSWERS
Asked by kia2012

CV Joint Not Resetting

2011 KIA SORENTO
I Am Replacing At Strut And I Can't Get Cv Joint To Reset Itself.
1 ANSWER
4 IMAGES
Asked by Jason Karasinski

Intermittent Slipping Out Of Gear

2011 KIA SORENTO
My Car Randomly Slips Out Of Gear Into Neutral While Driving From Once Every Other Day To Three Times Per Day. It Slips Out Of Gear From...
1 ANSWER
5 IMAGES
Asked by jmd777

Loud Clicking Noise When Put Into Drive

2011 KIA SORENTO
When I Start My Car It Runs Good, But When I Put Into Gear It Is A Loud Clicking Noise.
5 ANSWERS
Asked by whatever18

High Rpm's Before Downshifting

2011 KIA SORENTO
The Vehicle Goes To About 3000 To 3500 Rpm's Before Downshifting When Going Uphills. Sometimes Unless I Put It In Cruise It Does Not...
1 ANSWER
Asked by blossom59

Browse other repair topics

Browse by repair topic
Bearing HubCV AxleDifferentialDrive ShaftTransfer CaseTransmissionWheel BearingWheel Stud

    Can’t find your issue?

    Ask a new Kia Sorento question