Jeep Wrangler Repair Questions and Answers


2002 Jeep Wrangler No Heat

2002 JEEP WRANGLER
The Vehicle's Heater Will Not Warm Up.we Replaced The Thermostat ( 190) And The Engine Heats Up To 210 To 220 On The Gauge , But No Heat...
1 ANSWER
Asked by kbussell

1993 Jeep Wrangler Fuel Pump

1993 JEEP WRANGLER
When The Ignition Is Turned On The Fuel Pump Does Not Kick In. The Fuel Pump Was Replaced And The Problem Is Still There. What Could Be The...
1 ANSWER
Asked by papawoody123

1987 Jeep Wrangler Help

1987 JEEP WRANGLER
The Rpm Are At 10 Then They Go 5 Then My Jeep Just Dies What Do You Think It Could Be
1 ANSWER
Asked by rick 1

1995 Jeep Wrangler Water In My Oil

1995 JEEP WRANGLER
Help! I Have Water In My Oil. They Drained, Flushed, Sealed, But It's Still Happening. There Is Not Water Leaking (on To The Ground) From...
1 ANSWER
Asked by kellybook@netzero.com

1995 Jeep Wrangler Belts

1995 JEEP WRANGLER
Hi, The Belt On My Jeep Is Fairly New, But Now It Is Squealing!! Its Not So Bad At A Neutral/idile Position, But When Going Through The...
4 ANSWERS
Asked by Heathwest1

1991 Jeep Wrangler BRAKE LIGHTS

1991 JEEP WRANGLER
I Recently Replaced My Brake Lights And Now The Brake Ligths Do Not Work. The Running Lights And Turn Signals Work Fine, Just No Brake...
1 ANSWER
Asked by clreed756

1993 Jeep Wrangler OIL PRESSURE

1993 JEEP WRANGLER
Our Jeep Was Low On Oil And Since Taking Care Of That The Oil Pressure Keeps Fluctuating Between High And Low At Higher Speeds
1 ANSWER
Asked by radamsmom2

1999 Jeep Wrangler Hazard Flashers

1999 JEEP WRANGLER
My Right Front And Side Turn Signal Lights Works Fine. But When I Turn On My Hazards, They Don't Flash At All. When First Turned On, The...
1 ANSWER
Asked by tripdog

2002 Jeep Wrangler Front Brake Pads

2002 JEEP WRANGLER
I Replaced The Front Brake Pads , Didn't Turn The Rotor's , Now Brake's Get Hot Fast When Used, Why? Glenn
1 ANSWER
Asked by glenbirk

1990 Jeep Wrangler Sreeching Noise Upon Start Of...

1990 JEEP WRANGLER
When I Start My Jeep When It Is Cold, It Behaves Normal Until I Engage The Clutch And Start To Move At Which Point There Is A Load...
1 ANSWER
Asked by brookie
Ask a new Jeep Wrangler question