Jeep P Codes (Powertrain)
Browse Jeep P Codes (Powertrain) questions and answers. Choose a question that matches your symptoms.
162 discussions
1997 Jeep Cherokee 1997 Jeep Char. P1763 Diagnosis...
P1763 Was The Diagnosis From Autozone. Definition Governor Pressure Sensor Too High.
Explanation: Ecm Dectected The Governor Sensior...
Asked by Milt Kostal
1996 Jeep Cherokee Obd2 Code P0340
I Have A 96 Cherokee 4.0 4wd 47,300mi . My Check Engine Light Is On And My Jeep Starts And Drive But Them Shuts Down As I Am Driving. I Used...
Asked by 96cherokee
1996 Jeep Cherokee Check Engine Code
1996 Jeep Cherokee 6 Cyl Four Wheel Drive Automatic
I Have 2 Codes That Came Up .po 138 Sensor High Circuit Voltage Bank 1 Sensor 2,and...
Asked by jee4pcherokee
1996 Jeep Cherokee Need Help
96 Grand Cherokee,4.0 These Codes Po351,po108,po443.where Do I Start Can You Help Me?
Asked by Deniece
1994 Jeep Grand Cherokee Engine Code
I Got Code That The #4 Fuel Injector Was Bad I Replace It, I Keep Getting The Same Code The Eng Runs Good Then It Sputters A Bit Then I Get...
Asked by sergio53
1994 Jeep Cherokee Check Engine Code '94 Jeep...
Have A '94 Jeep Cherokee, 206400 Miles, Auto, 4.0l I6 2wd. Have A "fuel Smell" In The Passenger Compartment, Coming From The Vent (not...
Asked by stormfront8401
1994 Jeep Wrangler Jeep Wrangler Engine Codes
I Have A Code 33 And 51 On My Jeep Wrangler. I Have Tried Changing The O2 Sensor Which Didn't Fix The Problem. The Jeep Runs Normal In Open...
Asked by poetikpunk
Is There A Better Way To Read Engines Codes On A...
Is There A Better Way To Read Engines Codes On A Cherokee Xj Sport, Than By Just Using The Dashboard Flashing Light Technique. Is There A...
Asked by TEXACA
P0121 & Transmission Problem
I Have A 2001 Jeep Grand Cherokee With An Intermitant Problem At Almost Any Speed. While Driving The Transmission Seems To Be Slipping Based...
Asked by jcstables
3-4 Shift Censor P0783
My Jeep Has Exactly That Problem In Will Back Fires Between 1 And 2 My Light Showed Up That Code Any Ideas On What Could Be The Problem....
Asked by joseadonnel
Browse other repair topics
Can’t find your issue?
Ask a new Jeep question
