JEEP DRIVETRAIN

I Was Told To Get Outer And Inner Wheel Bearings. Videos Online Show Replacing Hub Assembly. Does My Vehicle Need A Replacement For The Hub...

Is There A Common Issue On These? When I Put It In 4wd Mode I Hear The Transfer Case In The Middle Of The Car Making Noises. Its Louder Than...

I Want To Know If My Nsg370 Will Be Able To Connect To A 6.7 Cummings.

Clutch Is Fine For A Mile Or Two And Then No Pedal. Let It Sit For A Day Then Again Good For A Mile Or Two.

My Vehicle Listed Above Won't Go Over 65, And Will Not Go Into Overdrive. How Do I Fix It? It Is 4x4 Quadra Drive.

I Have The U Joint Replaced On The Driveshaft Just Fine. However, The Spindle Where The U Joint Sits To The Rear Axle, Where The Brackets...

The Arm At The End Of The Clutch Linkage That Goes Into The Clutch Housing Is Shaking And Jumping. If I Put Downward Pressure On The Arm The...

I Have To Replace The Front Left “driver Side” Lower Ball Joint Which (as Far As I Know) Requires The Removal Of The Axle From The Hub/...

After Putting A New Clutch About A Few Day Later I Was Driving And Suddenly The Jeep Got Stuck In Neutral And Does Not Go To Any Gear

One End Is Attached In Pic And The Other Is Just Hanging With The Plastic Thingy In The End. What Is This, Where Does It Go?