Honda Drivetrain

Browse Honda Drivetrain questions and answers. Choose a question that matches your symptoms.

2,686 discussions


96 Accord Standard Transmission. 9 Volts At Starter...

1996 HONDA ACCORD
96 Accord Standard Transmission. 9 Volts At Starter Signal Wire Changed Ignition Switch, Starter Cut Relay, Clutch Switch Works And Starter...
1 ANSWER
Asked by Anonymous

After The Roads Were Plowed, Some Of The Compacted Ice...

1996 HONDA PASSPORT
After The Roads Were Plowed, Some Of The Compacted Ice/snow Fell Into The Road. I Accidentally Drove Over The Pile And It Busted Up Beneath...
1 ANSWER
Asked by vfeast

How Do You Engage 4 Wheel Drive

1996 HONDA PASSPORT
How Do You Engage 4 Wheel Drive
1 ANSWER
Asked by Anonymous

My Car Turns On But When I Put It In Gear It Will Not...

1996 HONDA ACCORD
My Car Turns On But When I Put It In Gear It Will Not Go, It Sounds Like Its In Neutral. I Tried Reverse And All Other Gears And It Will Not...
1 ANSWER
Asked by Anonymous

The Right Rear Drive Shaft N My CR-V Pulled Out Of The...

1996 HONDA CRV
The Right Rear Drive Shaft N My Cr-v Pulled Out Of The Diff. The Oil Ran Out Ect. On Opening The Back Of The Diff I Could Not Find Any Clips...
1 ANSWER
Asked by mmilne68

Transmission Not Shifting With A Darn?

1996 HONDA ACCORD
96 Honda Accord Shifts When Its Cold But Won't Shift When Its Warmed Up
30 ANSWERS
Asked by quickmech

I Have Been Having An Issue With My New Clutch System...

1996 HONDA PRELUDE
I Have Been Having An Issue With My New Clutch System. Yesterday, The Clutch Dropped Down To The Point Where It Let Out At The Bottom. I...
1 ANSWER
Asked by mattmycko

My Power Streering Gear Box Is Leaking Fluid, What Can...

1996 HONDA CIVIC
My Power Streering Gear Box Is Leaking Fluid, What Can I Do To Repaire It
1 ANSWER
Asked by Anonymous

I Have A 1996 Honda Accord Manual And The Car Will Not...

1996 HONDA ACCORD
I Have A 1996 Honda Accord Manual And The Car Will Not Shift Once The Car Has Started.
1 ANSWER
Asked by superstarof88

Clutch

1996 HONDA PRELUDE
Hello, I Have Replaced The Clutch Master Cylinder And The Slave Cylinder On A 96 Prelude. And I Will Get A Little Pressure And...
1 ANSWER
Asked by Robert85

Browse other repair topics

Browse by repair topic
Bearing HubCV AxleDifferentialDrive ShaftTransfer CaseTransmissionWheel BearingWheel Stud

    Can’t find your issue?

    Ask a new Honda question