Holden
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
How Too Reinstall Rear Seat Cushion's In A 2002 Holden...
I Have A 2002 Holden Berlina Sedan And Have Replaced Rear Seat Belts But Have Had Too Partly Remove Rear Seat Back Cushion And Would Like...
Asked by Chris71
Engine Won't Idle But Has Good Power When Under Way
My Wife Has Just Bought A 2001 Holden Vectra 2.2 Automatic Gl. It Goes Well But Is Idling Very Roughly And Making A Tapping Sound. The...
Asked by grumblebum6142
Why Wont It Start.whats The Fault
Holden Barina 2000 Spanish Model.wont Start.battery Ok (new).turns Over Fast.no Spark.coil Ok.no Dash Board Lights.
Asked by bryan kelly
Cv Axle Is Stuck And Will Not Come Out
I Have A Nov 97 4wd Holden Rodeo And Need To Replace The Left Hand Cv Axel It Wont Come Out And I Think There Is A Clip Of Sorts.
Asked by kwild17
Problems When Starting
Only Happens Now And Then Not All The Time. Ignition Starts But Cuts Out. Takes A Few Attempts To Get Going As Well As Pumping The...
Asked by olesp
Possible Causes For Car Not Changing Gears
Own A Vy Ss Commodore With A 6 Speed Box. Coming Home Yesterday And Suddenly Was Unable To Change Gears (can Change Without Clutch When...
Asked by mantis84
How Do You Bleed The Clutch At The Belt Housing?
We Have Replaced The Clutch And Bled It Everywhere Except At The Belt Housing. We Are Having Trouble Working Out How To Bleed It There Is...
Asked by Jason Byron
Timming Holden Barina 95 Model 1.4l Motor
Hi I Have Just Rebuilt The Head On My Holden Barina 95model 1.4l Motor. I Kno I Have To Time It Tdc, Exhaust But My Problem Is There Is An...
Asked by chevy13365
Issues Starting Vehicle After Half Hour
Hi Ive Had Issues Starting My Vr Commodore V6 After Half Hour It Will Crank For About 6-10 Secs Then Start Sluggishly. Ive Had Replaced The...
Asked by brockandtayla
Firing Order And How 2 Set Timing On My 1.4l Engine
I Have Just Rebuilt The Head,i Have Alianed Tdc On Number 1 Piston, Alained Both Crank Pully And Head. The Rotor Is Faceing Number 1 Plug...
Asked by chevy13365
Ask a new Holden question
