GMC
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
AC/Heater Blower Motor Location
A/c, Heat And Defrost Not Blowing At All.. Was Working Fine When I Went Into My Dr Appt And When I Started The Vehicle I Had Nothing Blowing...
Asked by NickDamone83
Power Window Relay Location
Had Issues With Power Window Switches Not Making Contact. Took Apart And Cleaned Connections And When I Was Done They Wouldn't Work At...
Asked by NickDamone83
When I Start My Truck I Smell Gas After It Runs For A...
I Was Told To Check The Catalytic Converter To See If It Glows Red. I Haven’t Seen It Glow Yet. I’m Assuming That The Oxygen Sensor...
Asked by James Black
A/C Works And Blows Cold Air, But After A Few Minutes...
While On My A/c Control It Shows That It Is On And It Starts Blowing Cold Air Again After A While, And It Is A Constant On And Off. Keep In...
Asked by Grace1120
60 MPH Steering Wheel Vibration
Whenever I Drive 60mph My Steering Wheel Vibrates. Can Anyone Help My Correct This Issue.
Asked by xtwiand
No Oil Pressure
Engine Shuts Off As Soon As I Start It. I Know This Is A Safety Feature For The Engine. I Have Changed The Oil Pump, Cleaned The Oil Pan...
Asked by Freestylefrank
No Start Condition
The Truck Was Running Just Fine Then I Got Code For A Cam Sensor. I Did A Check On The 12v Positive And Ground And They Were Fine, But My...
Asked by rca195203
Rear Door Lock Actuator Clicks But No Movement
I Replaced The Actuator However The Actuator Does Nothing. I Do Have 12 Volts Going To The Plug For The Actuator. Any Ideas?
Asked by ROLII
Leaking Coolant
Intake Gasket Replaced 1500km Ago By Dealer Looking For Cheaper Fix. Is Barsall Engine Stopleak Compatable With Aluminum Intake And Cast...
Asked by Rod Edlund
Slow Coolant Leek
Intake Gasket Replaced By Dealer 1500km Ago. Looking For Cheap Repair. Is Barsall Engine Stop Leek Comparable With Aluminum And Cast Iron.?
Asked by Rod Edlund
Ask a new GMC question
