GMC


Front Vents Not Working Properly

2010 GMC ACADIA
All Vents In The Front Blow Cold When The Heat Or Defrost Is On. Rear Vents Blow Heat Properly. All Vents Blow Cold Air For A/c.
1 ANSWER
2 IMAGES
Asked by Sanni Sanni

Fuel Injectors Not Working Properly

1988 GMC S15
Getting Gas To The Fuel Injectors But They're Not Spraying.
1 ANSWER
1 IMAGE
Asked by JasonL77

Electric Lift Gate Not Working Properly

2014 GMC YUKON
I Have The Vehicle Listed Above Xl Denali. The Lift Gate Outside Opening Switch Stopped Working, But The Remote Would Still Open And Close...
1 ANSWER
15 IMAGES
Asked by rc51jim

A/C Clutch Not Engaging Properly

1995 GMC C1500
A/c Compressor Clutch Gets Noisy Under 1,000 Rpm's And Clutch Will Not Engage Unless You Tap On It. Even Though It's Noisy It Still...
17 ANSWERS
23 IMAGES
Asked by Mark Underwood2

Brakes Feel Like They Are Grabbing Just As I Come To A...

2003 GMC SONOMA
When Coming To A Stop It Feels Like The Brakes Are Grabbing Briefly And Then Releasing.
1 ANSWER
Asked by RWALLA343

No Air Is Coming Through The Defrost Windshield Vents

2006 GMC C1500
All Other Vents Are Producing Hot/cold Air Just Fine. Fuses Are Good And Blower Is Working Along With Temperature Switches.
1 ANSWER
2 IMAGES
Asked by kloffK

A/C Clutch Not Engaging

2001 GMC SIERRA
Truck Listed Above Is An 1500 Hd. About 8 Weeks Ago I Started Having Trouble With My Truck Starting. The Starter Wouldn't Crank...
91 ANSWERS
40 IMAGES
Asked by Fro250

Runs For A Few Minutes Then Sputters And Shuts Off

2004 GMC ENVOY
It Started Where I Could Drive It For About 10 Minutes Then It Would Lose Power And Shut Off. Later That Day, I Figure Drive It To A Local...
1 ANSWER
Asked by uncle_Joe

Camshaft Sensor Replaced Now Engine Cranks But Does...

2010 GMC TERRAIN
I Have Replaced The Camshaft Sensors And Crankshaft Sensors After Light Engine On And Codes Appeared P0016, P001. Now The Car Crank But Not...
5 ANSWERS
6 IMAGES
Asked by Omeribrahim

Battery Will Not Hold A Charged

1996 GMC SIERRA
So Hearsay My Battery Drains Flat During The Day. I Had It Jumpstarted And Left The Truck Running For Over An Hour. It Started Fine This...
1 ANSWER
Asked by Jeffb333
Ask a new GMC question