Ford S-Max
PCM Location Codes P0606:00-27, P062E:11-2C?
Hello
Where Is Pcm Location Under Hood
Thank You
Asked by jutrisad
Starting Issue?
"i Have A 2006 S-max 1.8 Tdci (qywa). The Turbo, High-pressure Pump, Map Sensor, Injectors, New Battery, Iat Sensor, Glow Plugs, Upper...
Asked by Géza Kovács
Where Is The Blend Door Actuator Located?
Could Anyone Please Help Me Out With The Location Of The Blend Door Actuators Left And Right. The Vehicle Listed Above Has 1.8tdci Diesel.
Asked by Willnev2020
Refurbished Turbo Fail?
Hello,
2006 1.8 Tdci (125hp). A Refurbished Turbo Was Put On It (+oil And Filter,+gasket), Electronics Remained The Same (old Turbo Ate...
Asked by Géza Kovács
MAF Sensor Voltages?
Hi. If I Unplug The Maf Sensor Connector, 5v Can Be Measured On The Signal Line. According To Autodata, There Should Be 0 Volts In This...
Asked by Géza Kovács
What Type Of Gear Oil Should I Use?
Hello, I Need To Change The Gearbox Oil On This Car, Can You Tell Me What Kind Of Oil And Where Is The Overflow Screw? This Model Has 6...
Asked by Alessandro albertin
How To Replace The Gearbox Oil?
Hallo, I Need To Change The Gearbox Oil On This Car, Can You Send Me A Step-by-step Guide?
Asked by Alessandro albertin
Shaking Steering
I'm Experiencing Shaking On The Steering Wheel Even Though I Have Had Balance And Enlightenment Done.
Asked by ryanglaz1986
Slipping Gears
I Had Slipping Gears, My Dual Clutch Was Changed And Gearbox Was Rebuilt. But Still Have Slipping Gears. The Engine Revs But Car Not Moving...
Asked by Raf Mapag
Starting Problems With White Smoke
My Vehicle Struggles With Starting When Cold, Once Started And Running After 5 Minutes All Is Fine And I Can Drive The Car As Normal And...
Asked by Richard148
Ask a new Ford S-Max question
