Ford Probe Repair Questions and Answers
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTrouble CodesWarning Lights
1990 Ford Probe Ecu
Computer Problem
1990 Ford Probe 4 Cyl Two Wheel Drive Manual Tomuch Miles
Hi I Was Wondering Is Possiable To Swap Out A 2.2l 4 Cyl Non...
Asked by soilborn
1997 Ford Probe Sputtering, Bogging
Car Starts Easily And Idles Well But Will Bog Down And Backfire At Anything Above The Very Smallest Throttle Opening. I Have Seen Many...
Asked by timprobegt
1994 Ford Probe The Engine Seems Sluggish And...
Engine Performance Problem
1994 Ford Probe 6 Cyl Front Wheel Drive Automatic 244k Miles
Despite A Full Tune Up, Except Ignition Wires...
Asked by davidtopgear2002
1996 Ford Probe Egr Sensors
Check Engine Light On For A Couple Days Then Off For A Couple Days About 2 Months Now Codes P1195 (boost Sensor)and P1402 (valve Position...
Asked by tyovan
1989 Ford Probe Attempted R12 Conversion
Conversion Attempted. Gauge Reads 60+ Lbs On Low Side But Compressor Still Wont Start. Fuse Is Good As Pulling Fuse Makes Cooling Fan And...
Asked by markisboss
1997 Ford Probe Crank Position Sensor Causing The Car...
We Can Usually Jiggle The Connector Thats On Top Of The Manifold And The Car Will Start And Work Fine For A Good Long Time. This Time Its...
Asked by kcwonder
1991 Ford Probe Car Chugs
About Two Months Ago My Car Stopped Working. It Would Die If It Was In Idle Or Park Or When I Went To Drive. Come To Find Out, There Was A...
Asked by jessikae
1992 Ford Probe Clutch Problems
Transmission Problem
1992 Ford Probe 6 Cyl Front Wheel Drive Manual
One Day, My Probe's Clutch Stuck To The Floor At An Intersection...
Asked by Glendias
1995 Ford Probe Im Sick Of Pushing My Car...
Just Bought This Probe, So Excited, First Car. Well When I Go Up Hills If I Dont Get A Headstart I End Up Going About 5mph Up The Hill, And...
Asked by myprobesux89
1989 Ford Probe Smoke From Exhaust
The Oil Compression Gage Is Always On Low Even After Oil Is Added And Full. It Burns Oil Quickly-always Have To Add More, No Dripping In...
Asked by Delbert Wega
Ask a new Ford Probe question
