Ford F-150 Repair Questions and Answers
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
1997 Ford F150 Bleach In The Gas Tank
My Truck Was Vandalized In Oct Of 2007. Bleach Was Reported In The Fuel System And My Engine Kept Stalling Out.. It Turned Over Just Fine...
Asked by neums01
2004 Ford F150 Truck Shakes
My F150 Has Started To Shake When I Apply The Brakes With Any Force. I Have Replaced The Front Rotors And Pads Thinking That Was The...
Asked by bnafries
Replaced Front Caliper, Pads And Rotors But Have A...
I Have Replaced Front Caliper, Pads And Rotors But Have A Squeak When Brakes Are Applied. Do You Have Anything Else I Could Try.
Asked by Paul Morrell
1993 Ford F150 Ignition And Or Fuel Problem
1993 Ford F150 V8 Four Wheel Drive 218, K Miles
Truck Was Running At Idle At Stop Light, Started To Forward On Green. Truck Motored...
Asked by aubrey sanders jr
1990 Ford F150 Fuel Pumps Run Continously
I Am Stumped! When I Turn The Ign. On The Fuel Pump Will Continiously Run. It Should Run For About 2 Seconds Which It Does When The Light...
Asked by Bandit40
1998 Ford F150 Battery/alternator/voltage Regulator
My Check Battery Light Has Come On, My Battert Tests At 12.5 When Engine Is Off, But When I Start It The Voltage Goes Done To 10 Volts. I...
Asked by cherfharryo
1997 Ford F150 My 4.2 Engine Having Problem Up To 30...
Hello And Thx For Reading My Post,anyways My Truck Has A Problem With Accelerating From 0 Up To 30 Mph After 30mph Thing Seem To Smooth Out...
Asked by locok26
1987 Ford F150 Tach Please Reply Soon
My Truck Was Quiting It Doesent Get Any Fire And I Put A New Distributor On It And It Ran Fine But I Didnt Have The Tach Hooked Up. When I...
Asked by fordboy88
1992 Ford F150 Computer
I Am Trying To Replace The Front Computer On The Drivers Side Under The Front Fender And I Am Not Sure How It Unplugs . Any Advice
Asked by csivert
1996 Ford F150 Please Reply As Soon As Possible...
Used Engine, Blow Cylinder Head Gasket, Diassemble The Cylinder Head From Engine, Repair Heads, Reseat Valves, Fit Valves Stem Seals...
Asked by Kimantia
Ask a new Ford F-150 question
