Ford Explorer Engine

Browse Ford Explorer Engine questions and answers. Choose a question that matches your symptoms.

2,057 discussions


Will Not Crank All Dash Warning Lights Come On?

2009 FORD EXPLORER
The Car Has A New Battery. All Terminals Are Clean And Tight. All Fuses Checked. Tried Resetting The Security System Per Ford. Starter Turns...
1 ANSWER
7 IMAGES
Asked by bobjet2001

Intermittent Noise On Acceleration

2009 FORD EXPLORER
About Halfway Through The Video, It Really Starts. My Mechanic Did A Tune Up And Replaced A Fuel Injection That Was Leaking But It Didn’t...
5 ANSWERS
1 VIDEO
Asked by mommafrog63

Getting Code B1342, RSC And ABS Lights And Chime

2009 FORD EXPLORER
My Wife's Suv Has Been Getting The B1342 Code, It Is Becoming More Frequent. I Have The Auto Enginuity Scan Tool With The Total Ford...
9 ANSWERS
5 IMAGES
Asked by Keith Mueller

Cylinder Head Replacement

2009 FORD EXPLORER
Do You Have To Pull The Engine To Change Heads?
1 ANSWER
31 IMAGES
Asked by tim@a6services.com

MAF Signal Wire Reading At 18.7 V?

2008 FORD EXPLORER
Vehicle Details: 4wd / Awd Ecl Light Is On And Showing P102 Code Mass Or Volume Air Flow Circuit Low Input I Tested The Wire Directly...
4 ANSWERS
9 IMAGES
Asked by rolfreen

While Driving My Vehicle Will Periodically Go Into A...

2008 FORD EXPLORER
If I Turn The Vehicle Off And Restart It, It Runs Fine For A While But Eventually It Will Do It Again. It Usually Happens Under Acceleration...
7 ANSWERS
1 VIDEO
6 IMAGES
Asked by Rustedtreasure116

Where Is The Camshaft Position Sensor Located And How...

2008 FORD EXPLORER
My Truck Has A Check Engine Light, And The Error Code Has Come Up With A Camshaft Position Sensor (circuit Bank 1). I Have Recently Been...
1 ANSWER
3 IMAGES
Asked by Kerri Anne Hoyte

Cranks No Start, New Battery And New Starter?

2008 FORD EXPLORER
Car Will Crank Won’t Turn Over Continues To Try To Crank Until Key Is Removed.
1 ANSWER
Asked by Bribum

Engine Shutting Off While Driving

2008 FORD EXPLORER
Hello, The Vehicle Shuts Off Any Time On The Express Way. When This Happens It Won't Crank At All If Attempt Is Made. Leaving The...
1 ANSWER
1 IMAGE
Asked by Blessing Ewobor

PCM Pinout Needed

2008 FORD EXPLORER
I Had Alldata Software And Can't Find The Pinout For The Pcm. Its 170 Pin Mvf3 9l2a-12a650-fd
35 ANSWERS
15 IMAGES
Asked by b_alzuabi77

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBlockCamshaftComputerCrankshaftCrankshaft PulleyCylinder HeadEstimateFlexplateFlywheelHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Ford Explorer question