Dodge Brake Pedal Goes to the Floor

Browse Dodge Brake Pedal Goes to the Floor questions and answers. Choose a question that matches your symptoms.

113 discussions

After Replacing And Bleeding The Brakes There Is No...

2014 DODGE RAM
Brake Change. No Pressure After Bleeding, Replaced Front Calipers, Service Electronic Brake System Lit Up During The Change Z No Leaks. I...
3 ANSWERS
5 IMAGES
Asked by sfina

Brakes Not Working After Being Involved In An Accident

2013 DODGE CHALLENGER
I Had Recently Had Mechanical Work Done To My Vehicle Because Of A Minor Accident (accident Had Caused Wheel To Completely Break Off And...
1 ANSWER
Asked by Brandon2314

Brake Pedal Fading?

2012 DODGE JOURNEY
Brake Pedal Fading.
1 ANSWER
Asked by Jonesy2008.cj

While Driving My Brake Light Came Back On And Within...

2012 DODGE CARAVAN
Yesterday Afternoon (5-25-19) I Had A New Tire Put On The Front Driver Side. My Brake Light Came On About An Hour Later, Fluid Was A Little...
3 ANSWERS
Asked by SC1990

Trailer Light Saying Trailer Brakes Not Working When...

2012 DODGE RAM
Trailer Light Saying Trailer Brakes Not Working When Nothing Is Plugged In
9 ANSWERS
Asked by Anonymous

Brake Fade

2011 DODGE CARAVAN
I Replaced Both Rear Wheel Bearings, All Four Rotors. All Four Pads, Shocks And Struts. Pedal Was Fine Before I Did This But Now Is Spongy...
6 ANSWERS
Asked by Psable

2011 Dodge Journey Brakes

2011 DODGE JOURNEY
I Replaced The Front Calipers. After I Bled The Brakes (assuming I Bled Them Enough) The Brake Peddle Firmed Up Without The Engine Running...
1 ANSWER
Asked by sybilwayne185

Brake Pedal Goes To The Floor

2010 DODGE RAM
Truck Listed Above Is A 1500. Cv Axles, Hubs, Brake Calipers, Rotors, And Pads. Bled Brakes Via Proper Procedure Multiple Times. Pedal Is...
3 ANSWERS
Asked by CRB94

Changed The Brakes And The Master Cylinder The Pedal...

2010 DODGE RAM
I Changed The Brakes On All Four Wheels, Discs, Pads Calipers And The Master Cylinder, And The Pedal Still Goes To The Floor, And There Is...
49 ANSWERS
Asked by Daniel Blais

Bench Bleeding The Master Cylinder

2009 DODGE CALIBER
They Send To Plastic Fittings To Screw Into The Holes And Say To Push The Rod Down No More Than An Inch Then Wait A Few Seconds For The Air...
4 ANSWERS
Asked by R.D.

Browse other repair topics

Browse by repair topic
ClickDragGrabGrindLock UpNoisePedal Goes to the FloorPedal HardPedal LowPedal SpongyPedal VibratesPullPulsateRubbingScrapeShakeSmell HotSmokeSqueakSquealStuck OnThumpVibrationWeakWorn

    Can’t find your issue?

    Ask a new Dodge question