Chrysler PT Cruiser Computer

Need Help With Resetting The Vlp Without A Scanner.

So, My Car Only Goes To Limp Mode After Going In Reverse To Back Up Then After I Shift Back To Drive It Will Go Into Limp Mode Almost Every...

Can A Bad Hub Bearing Or Cv Axle Cause Trans To Go Into Limp Mode On A 08 Pt Cruiser

I Have A 2008 Pt Cruiser Have Replaced The Computer Module And It Keeps Burning It Out . Is There A Reason Why It Would Keep Doing That

When Driven Above 3,000 Rpm's For A Little While The Dings And Goes Into Limp Mode Where Shifting Is Changed And Car Won't Go Over...

The C4 Connector Is Not Making Good Contact With The Pins. How Can I Remove The Pins? Is There A Tool And Tighten The Females?

Okay, I Changed The Asd Relay Out But Still Not Getting Anything From The Tipm Fuses 23 And 26 Relay Is Not Working. The Car Was In Lock Out...

I Replaced The Battery, Starter And Bought A Programmed Pcm And Had Alternator Checked, It's Good, New Fuel Pump Too. My Problem Is The...

Got This Car From A Tow Yard. What A Mistake That Has Been! It Was Intermittently Switching From Regular Driving Mode To Limp Mode And The...

How To Disassemble Pcm Connector? I Want To Tighten The Female Pins.