CHEVROLET S-10 DRIVETRAIN

02 Chevy S10 4.3l V6 It Seems I Need To Replace The U Joints, I Took It To A Shop They Say That I've Got Five U Joints. I Cannot Replace...

I Followed One Of Your Answers Removing The U Joints On The 1998 S10 2 Wheel Drive, 4 Cylinder. Melted Out Original Plastic, Etc. I Went...

My Clutch Has Been Making A Squeaky Noise For A Few Months. Today I Got In My Truck Pressed The Clutch And Turned Key To Crank It And The...

I Checked The Vacuum Actuator And It Seems Fine And There Is Vacuum To It. There Is A "motor Engaging" Noise Under The Truck By The Transfer...

Hi There. Not Sure If The Form Will Show It All So I'll Just Put The Info Here Too: 1996 Chevrolet S-10 118000 Miles 4.3 L Ho V6 ...

The Clutch Slave Cylinder Recently Went Bad In My S10. I Had The Slave Cylinder, Clutch Plate, Flywheel And Master Cylinder Replaced....

How Can I Change A U Joint. Do I Need To Drill Out The Plastic Hold In Pins To Press Them Out? They Are Hard In There

I Own A 1998 S10 Standard Tranmission With Approx 80,000 Miles, 4 Cyclinder 2.2 L. I Recently Had Overheating Problems And Had It In The...

Hi, I Read Your Post About How You Used The 3/8 Copper Pipe And Some Pvc And Things To Fix The Clutch Pedal Where It Broke Up In The...

I Have A 91 S-10 And The Front Drive Shaft Seems To Be Broken In The Middle. When The 4wd Is Turned On The Half That Comes From The T-case...