Chevrolet Engine

Browse Chevrolet Engine questions and answers. Choose a question that matches your symptoms.

24,965 discussions


Cylinder Two Misfire

2012 CHEVROLET AVALANCHE
My Truck Listed Above Has A Bad Miss On Cylinder Number Two. I've Already Tested The Plug, Wire, Coil Pack, And Injector, All Are...
1 ANSWER
Asked by Viperking75

Camshaft Position

2012 CHEVROLET TRAVERSE
Car Just Had Motor Replaced With Rebuilt One. Before The Original Motor Went Bad It Had A Miss And The Rpm's Jumped Did Not Throw A Code...
1 ANSWER
1 IMAGE
Asked by jmbartl

PVC Hose Or O2 Sensor

2012 CHEVROLET CRUZE
It Was Jumping When Idle. It Overheated At One Point And Had A Leak With The Antifreeze. This Is When I Took It In The First Time. They Said...
5 ANSWERS
Asked by lchristy

Runs Rough In Reverse And In Park

2012 CHEVROLET MALIBU
Just Started After Having No Previous Issues. Recent Tune Up. It Misfires/runs Rough In Reverse And When Put In Park. In Drive It Runs...
1 ANSWER
Asked by Cheeva2006

Engine Replacement Sounds Like Rocks Rolling Around In...

2012 CHEVROLET CAPTIVA
Had Engine Replaced On Thursday. Picked Up Car, And Drove It For Four Minutes. Sounded Like Rocks Rolling Around In The Engine. What...
1 VIDEO
7 IMAGES
Asked by msholleewood

Engine Shut Off While Driving

2012 CHEVROLET TRAVERSE
The Car Shut Off While Driving Down The Road. Tried To Restart It And All Electric Went Out. Turn Switch To Off Then Tried To Restart Again...
5 ANSWERS
12 IMAGES
Asked by jeffnwv

Vacuum Lines Diagram

2012 CHEVROLET SILVERADO
How Do I Get A Vacuum Line Diagram For My Truck Listed Above? Thanks Much.
35 ANSWERS
4 IMAGES
Asked by Dale Provance

Oil Everywhere After Dealer Changed The Oil

2012 CHEVROLET CRUZE
I’ve Had My Car For Four To Five Years About A Month A Go Was The First Time I Took My Car To This Specific Dealership For An Oil Change....
3 ANSWERS
Asked by Kkitch4

Engine Racing After Cleaning Throttle Body

2012 CHEVROLET SILVERADO
I’ve Been Having Trouble With The Engine Stalling So I Cleaned The Throttle Body. It Was Filthy. I Actually Removed The Four Bolts And...
1 ANSWER
Asked by Dale Provance

Balancer Pulley

2012 CHEVROLET CRUZE
After I Replace My Crankcase Front Seal, Do I Need To Grease The Outer Shaft Of The Pulley That Will Be Flush To The Seal To Prevent Burning...
13 ANSWERS
16 IMAGES
Asked by maholmes

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickDrain PlugEstimateFlexplateFlywheelGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil Level SensorOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Chevrolet question