CHEVROLET CYLINDER HEAD

I Recently Had The Head Replaced By Wifes Uncle. When He Started It Up After Putting It All Back Together It Ran Fine, However It Was...

Real, Correct, Fool Proof Way To Set The Valves (rocker Arms)needed. After A Manifold Gasket Replacement I Am At The Point That I Need To...

After Replacing Intake And Valve Cover Gaskets The Car Starts Up Rough And I Get This Code And A Cylinder 3 Misfire Code. Not Sure What I...

My Husband Is Needing The Torque Specifications On The Head Bolts & Camshaft Carrier Bolts For A 2013 Chevy Sonic Lt 1.8l Engine. Can You...

Can Someone Write Out Simply Instructions For Installing Them, And If There's Any Tolerances That Need To Be Checked. I'm Simply Asking...

Hello Again, Initially, We Were Told That There Was An Issue With The 3.4l Overheating Due To The Failure Of The Intake Manifold...

While Putting The Valve Cover Back On A New Rebuilt Engine To Be Installed In My Older S10 A Bolt Snapped Off. The Bolt Head Snapped Off So...

I Took Down A 89 Vette With Aluminum Heads Today With A Blown Head Gasket. I Noticed That The Three Water Ports At The Top And Bottom Of The...

Some Say No And Say Yes. I Have A Lifter Tic Noise Using The Above Combination On A New Rebuild. Thank S" I Rebuilt A 1096 454 Chevy Motor....

Engine Mechanical Problem 1983 Chevy Caprice V8 Two Wheel Drive Automatic Can I Use 350 Heads On A 305