Chevrolet Crankshaft

Browse Chevrolet Crankshaft questions and answers. Choose a question that matches your symptoms.

350 discussions


Rear Main Seal On A 92 S10blazer 4.3 V6

1992 CHEVROLET BLAZER
I Was Driving Home And Started To Smell Oil. I Drove It Straight Home And Parked, Got Out And There Was A Steady Drip For A While Then Quit...
1 ANSWER
Asked by numlock187

92 Chevy Calalier

1992 CHEVROLET TRUCK
I Have A 92 Chevy Calalier 2.2,4cyl,my Son Took My Car To Work The Other Day,it Drove Good ,no Proublems Going To Work Parked It And Came...
2 ANSWERS
Asked by neta52

Crankshaft Position Sensor Location Needed

1991 CHEVROLET CORSICA
Car Has Been Starting Fine, But Shuts Off Within A Few Minutes By The Time It Gets Close To Operating Temperature. Symptoms Sounded Like...
1 ANSWER
4 IMAGES
Asked by craigchap

Are Parts From A 2.8 S-10 Motor Compatible With Parts...

1991 CHEVROLET BLAZER
I Need A New Crankshaft For My S-10 Blazer And It Has The 4.3 Vortec, Are Parts Like That Compatible With A 2.8 S-10 Motor?
1 ANSWER
Asked by Dhunter830

Chevy Corsica Crankshaft Position Sensor

1991 CHEVROLET CORSICA
My Corsica With 3.1 Engine Began Stalling At Highway Speed A Few Days Ago. After Stopping For A Short Time It Would Restart And Run Again...
6 ANSWERS
1 IMAGE
Asked by tcambler

1991 Chevy Lumina Crankshaft Sencer

1991 CHEVROLET LUMINA
My Crankshaft Potion Sencer Is Broke Off Flush With The Block And I Was Woundering If There Was A Way To Get It Out Now?
1 ANSWER
Asked by Tommy1985

Car Dies While Running And Won't Restart. Replaced...

1990 CHEVROLET CELEBRITY
Car Dies While Running And Won't Restart. Replaced Crank Position Sensor. Also Replaced Connector. (does Polarity Matter On A 2 Wire...
3 ANSWERS
Asked by dra2650

Building A Sbc 400 One Of The Main Caps Do Not Line Up...

1990 CHEVROLET TRUCK
I Am Building An Sbc 400 The 3rd Main Cap From The Front Will Not Go Into Place As The Other Ones Do. It Fits Backwards,there Is About A...
5 ANSWERS
Asked by andrew72400

1990 Chevy Beretta No Fire Thru The Plugs

1990 CHEVROLET BERETTA
Electrical Problem 1990 Chevy Beretta 6 Cyl Front Wheel Drive Automatic 189k Miles My Beretta Has Ran Fine The Past Year That I Have...
2 ANSWERS
Asked by stratogod.69

1990 Chevy Corsica Crank Position Sensor

1990 CHEVROLET CORSICA
How Many Ohms Is Ok? Where Do You Check For The Ohms? Where Is The Sensor? Should The Ignition Be On Or Off When Checking?
1 ANSWER
Asked by cheriann62

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadDipstickDrain PlugEstimateFlexplateFlywheelGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnock SensorMAP SensorMass Air Flow SensorMountOilOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil Level SensorOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Chevrolet question