THROTTLE BODY POSITION SENSOR Questions

1990 Chevy Camaro

1990 CHEVROLET CAMARO
So Here Is My Car It Started Running Sluggish And Wnen I Would Step On The Gas It Would Not Acelerate It Would Choke Up But Not Turn Of .so...
2 ANSWERS
Asked by cesarelsecre

Acceleration Delay

2003 HYUNDAI ELANTRA
2003 Hyundai Elantra When Car Is Cold It Starts Fine But Will Not Accelarate Even If I Floor It For A Few Seconds. Does Not Even Rev Up...
2 ANSWERS
Asked by momah2o

Dodge 98 Intrepid Dies

1998 DODGE INTREPID
I Have A 98 Intrepid That Had An Engine Swap Done A Couple Of Years Ago (2.7 To 3.2). I've Been Using The Same Computer That Was On The 2.7...
8 ANSWERS
Asked by jmullins

1989 Chevy Camaro Tps Volts?

1989 CHEVROLET CAMARO
Electrical Problem 1989 Chevy Camaro V8 Two Wheel Drive Manual What Should The Tps Volts Be On A 89 Iroc- Camaro With A 5 Speed And A...
1 ANSWER
Asked by crazy)_yankee626

1995 Pontiac Transport Low Tps Vlts

1995 PONTIAC TRANSPORT
Engine Performance Problem 1995 Pontiac Transport 6 Cyl Front Wheel Drive Automatic 250.00 Miles This Van Stalls After Warm Up .there...
1 ANSWER
Asked by jkmcdonald

Tps Sensor Is Clicking Really Bad

1985 PONTIAC FIERO
I Have A Fiero, 2.8l, The Sensor Below The Tps Sensor Is Clicking Really Bad When I Turn The Ignition Key So Only The Electronics Are On....
1 ANSWER
Asked by rise474

1999 Jeep Cherokee Tps

1999 JEEP CHEROKEE
I Relaced The Tps On The Grand Cherokee And It Will Start Idle For A Second And Then Die, I Hooked A Computer Up To It And The Reading Says...
1 ANSWER
Asked by andrewshstn

Signal Cable In TPS

1997 LANCIA OTHER
Hello, Can You Show Me, Which Cable Is For Signal On Tps In 1.6l Engine 16v (76kw) ? Lancia Delta, Fiat Bravo/brava/marea - All Cars Use The...
1 ANSWER
Asked by Synthy

1992 Buick Lesabre Tps Setting And Adjustment

1992 BUICK LESABRE
What Is The Setting For Tps In Volts And How To Do Adjustment
1 ANSWER
Asked by DOM SR

2002 Chevy Suburban Tps Instolation

2002 CHEVROLET SUBURBAN
Im Putting In A New Tps And Am Not Sure If Anything Has To Be Done To Set Or Program The Ecm
1 ANSWER
Asked by tom potter