REPLACE/REMOVE SENSOR CRANKSHAFT Questions

I'm Replacing The Crankshaft Sensor That's Located In Between A Pulley And The Block. My Puller Tool Won't Fit Because Of The...

The Crankshaft Sensor Went Out On My Car Listed Above Turbo. I Replaced It And Now I Have A Po300 Multiple Engine Misfires And A Po725 Low...

Not Long Enough To Actually Go Anywhere And Extremely Rough. If I Put The Old One Back In It Will Run. The Reason I Am Replacing It Is As...

Changed The Sensor And It Will Not Start.

I'm Trying To Replace The Crankshaft Position Sensor On My Vehicle Listed Above. I Am Now Currently On My Third Crankshaft Position...

I Have A 2001 Nissan Maxima My Obd2 Scanner Was Throwing A P1335 Code. The Car Started Fine Ran Good But It Had A 0420 Code For Years Now....

Drove The Car Changed The Crankshaft Positioning Sensor Tried To Start The Car And Will Not Start.

Bought A New (non Mopar) Sensor And Installed It Due To The Rubber Gasket Being Broke And Leaking Oil.the Old Sensor Snapped And I Had A...

My Car Stop Running Ignition Crank Engine Turn But Not Running. I Run Obd Ii And I Getting Po341 And I Believe That Is The Crankshaft...

I Know That The Sensor Is In The Distributor. I Have A Repair Book That States The Distributor Needs To Be Replaced, But You Can Purchase A...