TRANSMISSION BELL HOUSING Questions

How To Take The Transmission Out?

1995 CHEVROLET BLAZER
I Have The Trans Pretty Out Only Thing I Havent Done Is Remove The Exhaust And Bell Housing Bolts. But I Cant Seem To Lower It Enough To Get...
4 ANSWERS
Asked by cboder218

Leaks Fluid Out Of The Bottom Near Where The Bell...

1999 FORD TAURUS
Leaks Fluid Out Of The Bottom Near Where The Bell Housing/transmission Join. There Is A Black Rubber That Looks Like It Might Be A Covering...
3 ANSWERS
Asked by Charlesmag

Ground Locations On The Manual Transmission Bell...

2005 SCION XB
There Is 3 Points On This Ground Cable. One To The Transmission, The 2nd To The Negative Battery, And The 3rd I'm Not Sure. It's...
3 ANSWERS
2 IMAGES
Asked by Scion

Dropping Transmission Down Clearance Problem

2005 FORD MUSTANG
Hello, Quick Question Regarding The Tr3650 Removal On The Car Listed Above Gt. I Recently Attempted This And Failed To Get The Transmission...
3 ANSWERS
6 IMAGES
Asked by alex67gto

Starter Issue, There Is A Broken Ground Strap From...

1993 CHEVROLET SILVERADO
Okay, One Day No Start. I Replaced The Starter. No Start, But There Is A Broken Ground Strap From Bell Housing. I Have No Idea To Where It...
1 ANSWER
Asked by acityklown

Colors Of Wiring On Driver's Side Under Truck...

1993 CHEVROLET SILVERADO
Need To Know What These Few Colored Wires Go To Drvrs Side Under Truck Closest To Bell Housing Purple And Light Green , Tan N Blue N Light...
Asked by Tammy K Mast

Wiring Diagram

1998 JEEP CHEROKEE
I Have A 1998 Jeep Cherokee Sport 4.0l 4x4 Automatic; Previous Owner Mentioned Swapping A 96 Model Engine In It. Was This An Actual...
2 IMAGES
Asked by XjChick

Will A Hope In The Bell Housing Prevent Car From...

1976 CHEVROLET NOVA
Can't Start Car. Might Have A Short Cause It Makes A Weird Electrical When I Turn The Ignition, And Now No Sound After. I Was Really...
Asked by Marty Lebar

F4A-EL To FN4A-EL Swap Possible?

2003 KIA RIO
I’m Just Curious Because Apparently The Only Difference Between The Two Is Internal. Does The Input Shaft And Bell Housing Line Up?
Asked by darranhall

Tansmission Problem

1996 GMC YUKON
So I Had A Crack In My Bell Housing Was Bad Leak Welded It Now No Leaks When I Put It In Gear Rpms Change And Will Move If I Reve It Up High...
Asked by billican81