clutch sticking

TOYOTA

ELYAG0

MEMBER
1 POST
FOLLOW

I have a toyota 4x4 1993 It had a new clutch presser plate and throw out baring put in it about
18 mouths ago. It stated sticking and then the pedal went to the floor by its self and I had to take my hand and pull it up. could the system need bleeding?

Jul 29, 2007 at 7:25 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

MHPAUTOS

CAR REPAIR CONTRIBUTOR
31,937 POSTS

Hi there,

I would first look at the master cyl & the slave cyl and check for leaks, Have a look under the dash where the clutch master cyl is mounted for oil leaks from the rear seal, repair and or replace as req and re bleed system.

Mark (mhpautos)

Aug 1, 2007 at 12:07 AM