SPONSORED LINKS

Sarting Problems

Tiny
TKENDIG55
  • MEMBER
  • 1995 NISSAN TRUCK
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 175,000 MILES
Trying to start the engine results in a click. Owner tapped the starter and it did work but that option doesn't work anymore. Replaced the starter but am still getting the same result. Old starter was tested and found to b weak but operational. Need to know where to go from here.
SPONSORED LINKS
Wednesday, April 19th, 2017 AT 11:37 AM

6 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Have battery tested including load test most places do for free make sure terminal ends are clean and tight.
Was this
answer
helpful?
Yes
No
+1
Wednesday, April 19th, 2017 AT 12:17 PM
Tiny
TKENDIG55
  • MEMBER
  • 5 POSTS
Had a volt meter on the battery when I tried to start it. It read 12.64V at rest and engaging the starter drew it down to 12.35V. I'm not sure that was a good test but I didn't see a major change under load.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, April 19th, 2017 AT 12:34 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Its ok but if it's not going down to like 10 volts, juice is probably not reaching starter recheck your work
Was this
answer
helpful?
Yes
No
+1
Wednesday, April 19th, 2017 AT 1:22 PM
Tiny
JOHNNY G.JR
  • MECHANIC
  • 320 POSTS
A voltage drop test should be tried, One lead of volt meter on positive battery post and other placed on positive starter post, turn key to start, If voltage drops.3 volts, possible bad connections, either end or bad battery cables, "internal corrosion"
Was this
answer
helpful?
Yes
No
Wednesday, April 19th, 2017 AT 7:25 PM
Tiny
TKENDIG55
  • MEMBER
  • 5 POSTS
I jumped across the solenoid and did get the starter to operate but the key has no effect. I wondered if the inhibitor relay could be the problem but I don't know it's location or how to properly test it
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, April 20th, 2017 AT 8:25 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Try resetting security system see link that may be the problem. relay check included as well.
https://www.2carpros.com/articles/how-to-reset-a-security-system
https://www.2carpros.com/articles/how-to-check-an-electrical-relay-and-wiring-control-circuit
Was this
answer
helpful?
Yes
No
+1
Friday, April 21st, 2017 AT 6:34 AM

Please login or register to post a reply.

Related Engine Not Running Content

How to fix an engine that wont start
VIDEO
How to fix an engine that wont start
Instructional repair video
Engine Not Starting
GUIDE
Engine Not Starting
Over the past 20 years at 2CarPros we have identified the top problems that are easily fixed. This guide can save you a trip to the repair garage or calling a tow truck and...
VIEW MORE

Sponsored links