Starter replacement

PONTIAC BONNEVILLE
Avatar
RFLANER
  • MEMBER
  • 2 POSTS
I need to change a starter on my mother-in-law's 1992 Bonneville SE, 3.8 L V-6, with 100,000 milles. I have never done one on a transverse mounted engine. Where do I start?
Aug 8, 2007 at 11:20 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CLY
  • CAR REPAIR CONTRIBUTOR
  • 308 POSTS
Lets see if we can get ya through this.....

1. Start by disconnecting the negitive battery cable.

2. Then from under the car remove the 10mm bolt that holds the flywheel inspection cover on.

3. Then remove the two bolts that hold the starter to the block.

4. Remove the two wires going to the starter and you should be able to tilt it down and out.

reverse the steps above for instalation...

Cly
Aug 9, 2007 at 5:25 AM
Advertisement
Avatar
RFLANER
  • MEMBER
  • 2 POSTS
[quote:eb7fd94928="Cly"]Lets see if we can get ya through this.....

1. Start by disconnecting the negitive battery cable.

2. Then from under the car remove the 10mm bolt that holds the flywheel inspection cover on.

3. Then remove the two bolts that hold the starter to the block.

4. Remove the two wires going to the starter and you should be able to tilt it down and out.

reverse the steps above for instalation...

Cly[/quote:eb7fd94928]
Aug 9, 2007 at 10:27 AM