1965 Ford Mustang

Tiny
KNIPPER
  • MEMBER
  • 1965 FORD MUSTANG
Engine Mechanical problem
1965 Ford Mustang 6 cyl Two Wheel Drive Manual

i have a 1965 ford mustang
it has an inline six 200 sprint engine 3.3 ltr (i believe)
it turns ove, has compression, the point and plugs are firing, and its getting fuel but it wont crank up
i have bought a new fuel pump
a new battery
a new sending unit and fuel tank
a new ignition coil
rebuilt the carburetor
and bought new plugs and wires
can anybody tell me why this engine wont run?
Monday, August 31st, 2009 AT 12:54 AM

5 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
The point and plugs are firing

Is the contact point gapped properly on the high side of the cam lobe? Is the coil getting full battery voltage or 9.5 volts? If so check ignition timing.

New pump and rebuilt carb should be getting fuel -choke plate is it adjusted properly.
Was this
answer
helpful?
Yes
No
Monday, August 31st, 2009 AT 1:10 AM
Tiny
KNIPPER
  • MEMBER
  • 3 POSTS
We have set the point gap to pretty much every single gauge
and its getting the full 12 voltage
i mean it should crank right up
it just wont do it
Was this
answer
helpful?
Yes
No
Monday, August 31st, 2009 AT 3:38 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Put engine no.1 piston on its compression stroke/TDC line the crank pulley to 0/TDC remove dizzy cap is the rotor pointing to the no.1 cap tower, also is it turning while engine is being crank over.
Was this
answer
helpful?
Yes
No
Monday, August 31st, 2009 AT 3:43 PM
Tiny
KNIPPER
  • MEMBER
  • 3 POSTS
Theres a chance its not lined up
but it turns while trying to crank
Was this
answer
helpful?
Yes
No
Monday, August 31st, 2009 AT 3:55 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
You need to make sure if the valve and ignition timing is correct otherwise its not gonna start.
Was this
answer
helpful?
Yes
No
Monday, August 31st, 2009 AT 5:45 PM

Please login or register to post a reply.

Sponsored links