I have a 89 ford crown vic. When you put the key in it will not turn. I have turnd the steering wheel bank and forth. and still nothing.
Mar 1, 2006 at 6:16 AM
Ignition switch
FORD CROWN VICTORIA
RMORRIS
- MEMBER
- 1 POST
Advertisement
PEPPERMRJ
- ✓ASE Certified Mechanic
- 1,158 POSTS
Welcome to the forum. :)
Have you tried a different key? Try pulling it out a hair and turning it. Try pushing it in firmly and see if it will turn.
The lock cylinders are not very expensive and fairly easy to install. I do believe you must be able to turn it to the on position tho. The down side is now the door key and the ignition key do not match.
Good luck and let us know. :?:
Have you tried a different key? Try pulling it out a hair and turning it. Try pushing it in firmly and see if it will turn.
The lock cylinders are not very expensive and fairly easy to install. I do believe you must be able to turn it to the on position tho. The down side is now the door key and the ignition key do not match.
Good luck and let us know. :?:
Mar 1, 2006 at 5:06 PM
2CARPRO JACK
- ✓ASE Certified Mechanic
- 11,533 POSTS
Post in the correct forum please
thanx
thanx
Mar 1, 2006 at 5:49 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.