Replaced upper rad hose on 2.2L and car runs hot. How do I bleed air from cooling system???
May 22, 2007 at 4:27 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
E40WATER12
CAR REPAIR CONTRIBUTOR
522 POSTS
Best thing to do is turn on youre cars heater up full blast at HI heat, allow youre car to idle with the resvoire cap off for about 5-10 mins. Place the rad cap back on youre car cooling system should be good.