1995 Chevy Beretta Ignition

1995 CHEVROLET BERETTA
193,000 MILES • 4 CYL • FWD • MANUAL
Avatar
BUBBABOY_6969
  • MEMBER
  • 2 POSTS
I have a 1995 Beretta and one day driving down the highway it started to lose its power. After it then died off I tried starting it but it only cranks but doesn not turn over and start. We hooked up a comp tester but it did not register it. I already changed the Ignition Module, and that did nothing and the fuel pressure is good. Any Solutions!
May 16, 2008 at 7:47 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MASTERTECHTIM
  • CAR REPAIR CONTRIBUTOR
  • 4,750 POSTS
do you have compression?
May 16, 2008 at 8:00 PM
Advertisement
Avatar
BUBBABOY_6969
  • MEMBER
  • 2 POSTS
Yes I do have compression
May 16, 2008 at 8:08 PM
Avatar
MASTERTECHTIM
  • CAR REPAIR CONTRIBUTOR
  • 4,750 POSTS
ok boss. i know fuel pressure is good but try spraying starter fluid into intake and see if it will run. if it does then we know we have a injector pulse problem. if it does not then check spark by pulling off a spark plug wire and rest it near a ground and crank over engine and watch for spark, if no spark then i woulod suggest replacing the crankshaft position sensor.
May 17, 2008 at 6:22 AM