Advertisement

shifter manaul

68,000 MILES • 4.9L • 6 CYL • 4WD
Avatar
EARLSAUTO
  • MEMBER
  • 1 POST
I recently put in a clutch and pressure plate because I have a problem. when I try to shift into high gear (fourth) it will not go into fourth right off. I have to keep trying. I had the shifter out and I noticed the pin that holds the shifter in is wobbled out and so is the hole. Also, the shifter goes right down into the transmission. Is there a bushing missing? And I put shifter into transmission in neutral. Is that okay? Someplace I read it should be in reverse. Thank you.
Jan 1, 2017 at 7:37 PM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
the shifter if anything may have a nylon bushing on bottom of shifter. However if this is gone it would effect all gears going in not one. you probably have either a bent/worn shift fork inside transmission or a the synchro is worn out for that gear.
Mar 24, 2021 at 5:10 AM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle