transfer case

2004 VOLVO S60
AWD
Avatar
JIM WAGNER
  • MEMBER
  • 2 POSTS
Recently had a transfer case (also called bevel gear, or angle gear) installed in my 2004 S60. After picking up the car the noise and problems are gone from the work, but I now have no oil pressure. Do the two have anything to do with eachother and what should I do. thanks
Jan 6, 2011 at 4:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
If engine had no oil pressure it would not run long think they disconnected oil pressure sensor on left rear engine
Jan 6, 2011 at 4:15 PM
Advertisement
Avatar
JIM WAGNER
  • MEMBER
  • 2 POSTS
how long can an engine run without oil pressure
Jan 6, 2011 at 7:08 PM
Avatar
JIS001
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 3,412 POSTS
No they are not related. Pull the dipstick out when the vehicle is running and see if there are bubbles in the oil. If there, then really common failure in this vehicles will be an internal oil leak from worn oil pick up tube seals.
Jan 9, 2011 at 10:13 PM