Fuel Pump and Fuel Filter

2004 KIA SEDONA
145,000 MILES
Avatar
L POWELL
  • MEMBER
  • 2 POSTS
As recommended both pump & filter were changed. Vehicle turns over but will not run. No codes show up when code reader used, Pump is working. Can fuel flow be interrupted anywhere? Can there be a air block? If so how would it be corrected? Is there a "in line filter"?
Jun 22, 2013 at 12:13 PM
Advertisement
Avatar
DOCFIXIT
  • ✓ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
This sounds like a crankshaft sensor that has gone out which will not set a code, here is a guide to show you what you are in for when doing the job. Also check the timing belt.

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

Here is the location for you car and the timing belt diagram.

https://www.2carpros.com/diagrams/kia/sedona/2004

Check out the diagrams (Below)

Please let us know what you find.

Cheers
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Jun 22, 2013 at 12:20 PM
Avatar
L POWELL
  • MEMBER
  • 2 POSTS
Yep it was the crankshaft sensor I replaced it and it started right up I got the sensor for $56.00
Jun 26, 2013 at 12:30 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.