Stalls while drive and then starts back up after a few minutes
brought to dealership and there are no codes and no lights or dash lights blink or come on
they can't figure it out
please help
Wednesday, June 3rd, 2015 AT 7:01 AM
1 Reply
SATURNTECH9
MECHANIC
30,869 POSTS
My first guess would be the crankshaft position sensor I have replaced a lot of them for that concern on that car. Sometimes they set a code sometime they dont if you had a scan tool read live engine data for rpms. When it wouldn't start you could see if the rpms were reading while cranking if they wernt most likely a bad sensor. The only other way would be to take And measure the ohms reading of the sensor when it wont start. When they go bad they will read as a open no value.A good one reads like 800 ohms or so.