where is the BCM and how do i scan this
Nov 18, 2010 at 6:10 PM
2002 ford wndstar
2002 FORD WINDSTAR
HARLEYRYDER
- MEMBER
- 6 POSTS
Advertisement
MMPRINCE4000
- ✓ASE Certified Mechanic
- 8,548 POSTS
BCM can be scanned at diagnostic link, but you need a Body scanner to scan it. Most DIY scanners will only scan "P" Powertrain codes.
High end scanners will scan all error codes, "B" body, "C" chassis, "P" powertrain, and "U" communication.
High end scanners will scan all error codes, "B" body, "C" chassis, "P" powertrain, and "U" communication.
Nov 18, 2010 at 6:17 PM
WRENCHTECH
- ✓ASE Certified Mechanic
- 20,761 POSTS
The "Front Electronic Module" is located under the dash on the driver's side. If you want to diagnose and scan this yourself, you are going to have to lay out about $10,000 for the scan tool to do it.
Nov 18, 2010 at 6:17 PM
JDL
- ✓ASE Certified Mechanic
- 16,098 POSTS
There is a front and rear electronic control module. The front is under left side of dash. The rear is right rear quarter panel. You may need a manufacturer's scanner to do what you need?
What's the problem? Any applicable trouble codes?
What's the problem? Any applicable trouble codes?
Nov 18, 2010 at 6:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.