2002 Dodge Dakota oil gauge

2002 DODGE DAKOTA
120,000 MILES
Avatar
CHRIS6911
  • MEMBER
  • 22 POSTS
when i start my truck, the oil gauge well go all the way to the high mark but i can still drive the truck and it runs fine. Puzzled about this.. Could it be my oil censer or my pressure switch? if so what is it that i can do ? I also need to know where the censers are in the engine.
Jun 11, 2013 at 3:01 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
You can check to make sure the pressure is within spec by using a mechanical gauge. It would plug into where the sending unit is located. My guess is that the oil sending unit is bad. It should be near the oil filter, but check it to make sure.
Jun 11, 2013 at 8:19 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
After thought... If you have the 3.9L V6, the sending unit is in the rear of the engine on top.
Jun 11, 2013 at 8:21 PM