Engine will not start?

I have replaced the sensors.I do have Spark and Injector pulse. Also fuel pressure is normal.I will check compression. Thanks

2002 PT Cruiser wont start - thought I ran out of gas but it didnt do any sputtering sounds before the engine just shut down. Towed the car home - no pressure in the bleeder valve for the gas so we replaced the fuel pump. Still wouldnt start. Ran the codes from the odometer P0340 - no camshaft position sensor signal at PCM - so we replaced the camshaft sensor - P1684 Battery was disconnected within last 50 starts - fuse error - burnt out IOD - so replaced that - also replaced the battery after it died from trying to start it so much - STILL WONT TURN ALL THE WAY OVER - it tries but never gets there. Please help -

I am havein the same problem same code dome some of the same things been told it was the timeing belt goin to break down and take it to the shop monday if you e mail me or look me up on here I will tell you what they say or if you have fixed it let me know how please user name scottndanielle posted the fule pump question on this same page

Replaced head in 2001 pt cruiser and now it wont start. It tries but got no fire

Replaced camshaft and crankshaft sensors just turn over wont start unhook camshaft sensor and it will start

Eng. Won't crank, starter doesn't click. Ing. Wiring good from switch to starter relay and from the relay to the starter solenoid. Grounded the relay trigger circuit. Starter works, eng. Cranks but will not start. Traced prob. To no ground for the starter relay trigger circuit. Tan wire from relay pin #86 tp pcm plug. Is good.

I have repaced the coil pack, negative and positive battcables, crank sensor, still won't fire any sugestions

It has fuel nospark does 02 pt cruiser have a ignition module?

I have fuel pressure I have spark, changed cam sensor because it had p0340 code also changed crank sensor, checked power going from plug for injecters only one wire coming from that plug has power also found that plug alittle melted because it was sitting on the postive cable for the starter pulled plug apart and
did not find and internale damage, tried starting the car it cranks, but the p0340 code keeps coming up and the car still will not start and it still says that the current sync is lost. Not sure what else to try but a rag and a
liter lol. Please help. Thanks

I have a 02 pt cruiser I have fuel spark and my timing marks are in line will not start

My son called me and stated his car wouldn't start. I tried jumping it with no luck, so I replaced the battery. I was able to get the car to start, but then it wouldn't shut off when the key was placed in the off position. I ended up pulling the Auto Shut Off Relay to get the car to stop running. I replaced the relay and it wouldn't start, so I disconnected the battery cables and touched them together and reattached. After messing around for several minutes turning the key on and off the car started again and again wouldn't shut off. I also noticed that when the car was off some of the dash lights (odo, air bag, etc) was still illuminated. The radio, AC, etc. Did not operate will the key was in the off position. The battery and Ignition Switch were both replaced during this process. At this time I'm puzzled and only have been successful in spending money with no improvement. Any suggestions would be greatly appreciated.

My car wont start, I have a gotten a new battery a new fuel pump new sensors and a new ignition coil. My alternator is good and my spark plugs are fine and I still do not know what will make the car start.