2001 Mazda b3000 replacing the starter

2001 MAZDA B3000
125,000 MILES • 3.0L • V6 • 4WD • AUTOMATIC
Avatar
EDMALONE
  • MEMBER
  • 1 POST
I can not get to the nuts holding the positive cable to the solenoid.the motor was replaced it went from a right mount to a left mount. I cant get to it there is no room to get in there. the bolts are out of the starter. if you have any suggestions I would appreciate it.
Dec 30, 2013 at 12:28 PM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
You will need to undo the engine mount and lift the engine slightly to get the starter out.

Here is a guide to give you an idea of what you are in for when doing the job.

https://www.2carpros.com/articles/how-to-replace-a-starter-motor

Please let us know if you need anything else to get the problem fixed.

Cheers, Ken

Jan 3, 2014 at 3:15 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.