2001 Chevrolet Tracker Motor Rolls Over Wont Start Tried Spraying Fuel Starter

2001 CHEVROLET TRACKER
90,000 MILES
Avatar
LOSTCARNUT
  • MEMBER
  • 8 POSTS
motor rolls over but wont start. tried spraying fuel and starter fluid in air intake still wont start. only thing I can think of now is spark, but I dont see any spark plugs. can you help me locate or have any other ideas
Dec 14, 2012 at 4:56 PM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Inspect and test the crankshaft positioning sensor -give me the engine liter
Dec 14, 2012 at 5:04 PM
Avatar
LOSTCARNUT
  • MEMBER
  • 8 POSTS
24 valve twincam 2.5 liter
Dec 14, 2012 at 5:09 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Crankshaft Position (CKP) Sensor (2.5L VIN 1) On front of engine, right of harmonic balancer.

Dec 14, 2012 at 5:25 PM
Avatar
LOSTCARNUT
  • MEMBER
  • 8 POSTS
How do a test it? with a voltage light? And do you have any other ideas in case that isn't it? It ran fine yesterday.
Dec 14, 2012 at 6:42 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Go to these links: https://www.2carpros.com/articles/car-cranks-but-wont-start and http://www.ehow.com/way_5471047_do-check-crankshaft-position-sensor.html
Dec 14, 2012 at 9:04 PM
Avatar
LOSTCARNUT
  • MEMBER
  • 8 POSTS
I tapped on gas tank and the car started. Does this mean the pump is bad or the sending unit or should I replace them both
Dec 16, 2012 at 9:06 AM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Replace the fuel pump
Dec 16, 2012 at 2:01 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.