SPONSORED LINKS

What can it be

Tiny
LECOW6
  • MEMBER
  • 2000 PLYMOUTH NEON
  • 4 CYL
  • FWD
  • MANUAL
  • 180,000 MILES
2000 Plymouth Neon, 4 cylinder, 180,000 miles. I have replaced Cam Sensor, Crank Sensor, Injectors, Spark wires, Coil, SparkPlugs, Front Axles and still after driving for 20 minutes the car starts to buck and jump as if missing. It throws an engine light of P1391. I am replacing the speed sensor tomorrow. No mechanic can tell me what is the problem. Engines idles and setting still at any RPM is smooth but under drive and after 20 minutes from cold start the problem begins. What can this be?
SPONSORED LINKS
Thursday, January 20th, 2011 AT 3:31 AM

3 Replies

Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
What about an ignition module? You can get them tested at auto store.
Was this
answer
helpful?
Yes
No
Thursday, January 20th, 2011 AT 5:12 AM
Tiny
LECOW6
  • MEMBER
  • 2 POSTS
Where is the ignition module located
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, January 20th, 2011 AT 1:45 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
I guess the 1.6 uses the DIS ignition system. No module. The code indicates intermittent signal loss to PCM from cam/crk sensors. When bucking if you put in clutch and rev does it run fine?
Was this
answer
helpful?
Yes
No
Friday, January 21st, 2011 AT 3:05 AM

Please login or register to post a reply.

Related Crankshaft Sensor Replace/Remove Content

Crankshaft Sensor Symptoms
GUIDE
Crankshaft Sensor Symptoms
Most modern car engines use a crankshaft sensor to monitor the engines crankshaft rotation. This sensor sends feedback information to the cars computer which then adjusts...
VIEW MORE

Sponsored links